IMG_0735.JPG

Dual 601 Belt-Drive Turntable Service

I’ve just had a classic Dual 601 belt-drive turntable in for a major service and it’s almost as good as new!

This particular Dual 601 needed recommissioning after an extended period of more than ten years in storage. The automatic tonearm functions were not working correctly and the deck needed a comprehensive grease and lube, plus proper tonearm setup.

So, for this Dual 601 service, I added synthetic oil to the dry main bearing assembly and carefully greased and lubed the key parts of the automated start and stop assembly, plus arm movement actuator. The automated tonearm movements were still not working though and this required further diagnosis.

This symptom is very common on the Dual 601, and other Dual turntables featuring an automatic arm return mechanism. I serviced another Dual 601 and discussed the problem here.

The problem turned out to be a small rubber part that had decayed and fallen off its original point of installation. Without this part, the tonearm can not be ‘gripped’ by the return mechanism and therefore won’t move. I fashioned a replacement part and now the arm works exactly as it should. I have used this repair methodology in several other Dual turntable repairs.

The owner was very pleased with the result of this major overhaul of his Dual 601. What follows are a few images of the deck and its internals.

IMG_0734.JPG
German, elegant and well-made, these are complex decks. The automatic mechanisms need extensive service at this age and many different and quite specific types of lubricant.
IMG_0736.JPG
At first, it’s hard to figure out what is going on. Many points to lubricate here…
IMG_0737.JPG
Trouble typically occurs here, often causing the tonearm not to return properly, or at all. In this case, a small rubber nipple that causes the arm to return had dissolved into nothing over time. This is a frequent source of trouble with Dual turntables.
IMG_0738.JPG
This master control cam needs to be carefully checked, cleaned of old grease and lubricated. I use a special synthetic grease of similar viscosity.

Thanks for reading and don’t hesitate to get in touch if you’d like your Dual 601 serviced and repaired.

5 thoughts on “Dual 601 Belt-Drive Turntable Service”

  1. Hi mate , do you know we’re I can get a counter balance weight for a dual 521
    Regards Gary.

    1. Hi Ben, thanks for commenting, hum problems have many causes so tracing the source is important. Cartridge issues, wiring problems in either the arm, connectors or lead-out cable, bad ground connections, ground loops between pre and power amp and so on. As I always suggest, if you are local, you could visit with the deck and I can do some troubleshooting for you. If you are not local, it becomes harder for me to help from a distance, unfortunately.

  2. Mike, do you have any other pictures or descriptions of the auto-return repair? Could this worn part also cause the initial grab and drop of the tone arm to malfunction as well?

    1. Hi Rich, only what you see in the article at this stage. There are many more photos, articles to be written and never enough time to put them together unfortunately!

Thanks for visiting, feel free to comment, like, share, subscribe. Be respectful to others, no advertising. Our advisory service is available via the contact page.

Discover more from LiQUiD AUDiO

Subscribe now to keep reading and get access to the full archive.

Continue reading

Scroll to Top